ultimaker cura - Anet A8 ignores extruder temperature? - 3D Printing Stack Exchange
Por um escritor misterioso
Descrição
I don't understand what's wrong with my G-code. I have set the printing temperature to 195 °C but when I try to print, the target temperature is always 0 °C and printing never starts.
I have tried
Creality CR 10 SE 3D Printer with Removable Bed and
ultimaker cura - Test print coming out spongy - 3D Printing Stack
g code - What is a printer console/terminal? - 3D Printing Stack
Anycubic Kobra 2 3D Printer, 6X Faster Speed Firmware
SUNLU S8 Pro 3D Printer, Large Build Size 15.7x12.2x12.2 inch FDM
Review: Monoprice Maker Ultimate 3D Printer
Anet ET4 3D Printer Fully Open Source with Resume Printing
Anycubic Kobra 2 3D Printer, 6X Faster Speed Firmware
My Anet A8's extruder won't go above 80 degrees Celsius. Any
Large Build Volume: Ultra-large forming volume allows you to print single model up to 300*300*340mm, or two of the same/mirrored model at the same
JGMAKER Large 3D Printer Artist-D IDEX Dual Extruder 3D Printers Direct Drive Extruder Linear Rail Large Build Volume 11.81x11.81x13.38in 98%
Cura 4.8.0 ; gcode temperature changes inconsistent with setup
g code - What is a printer console/terminal? - 3D Printing Stack
Anet A8 - guide, settings slicer, review, upgraded
de
por adulto (o preço varia de acordo com o tamanho do grupo)
